Goodmans Maxamp 30 and Maxim Speakers
SOLD

Nad 216THX Stereo Power Amplifier • 2 x 125 Watts continuous power into 8ohms 2 x 200 Watts into 4ohms • Dynamic Power 170, 280, 400 Watts into 8, 4 and 2 ohms respectively • Low loss, massive Holmgren™ toroidal mains transformer • Dual mono, Left and Right mirror image amplifier PCBs • Protection circuitry senses short circuits, DC and overheating • Bridgeable; 400 W into 8 ; 800W dynamic power into 4 SPECIFICATIONS - NAD 216THX Stereo Mode Continuous Average Output Power 125W (21dBW) (Minimum power per channel, 20Hz-20kHz both channels driven, with no more than rated distortion) Rated distortion (THD 20Hz-20kHz) 0.03%Clipping power (maximum continuous power per channel) 160W IHF dynamic headroom at 8ohms +1.3dB IHF dynamic power 8 170W (22.3dBW) (maximum short term power per channel) 4 280W (24.5dBW) 2 400W (26dBW) Slew rate >70V/sec Damping factor (ref. 8ohms, 50Hz) >200 Input impedance 60k + 500pF Input sensitivity (for rated power into 8ohms) 1.1V Voltage gain x 28.3 (29dBW) Frequency response 20Hz-20kHz ±0.2dB -3dB at 2Hz/100kHz Signal/Noise ratio ref 1 W 98dB ref. rated power 119dB THD + SMPTE I.M. + IHF I.M. <0.03% Bridged (Monophonic) Mode Continuous Average Power Output into 8ohms 400W (26dBW) (Minimum power per channel, 20Hz-20kHz,both channels driven, with no more than rated distortion) IHF dynamic headroom at 8ohms +1.5dB IHF dynamic power 8 560W (27.5dBW) (maximum short term power per channel) 4 800W (29dBW) Physical Specifications Dimensions (

SOLD

$450

Luxman LV-103 Hybrid Amp The hybrid Integrated Amplifier which adopted the Brid circuit which uses the thermionic tube excellent in musical reappearance power, and MOS FET of high speed high power. Interference distortion which current amplification causes is suppressed by throwing a triode into FET and the pre-driver stage, and supplying MOS FET to a final stage at the first rank, and also considering it as a voltage amplification over a whole page. Sharing of the feed line in a circuitry and an earth line was not carried out, but the S.T.A.R. circuit which connected all the lines from the reference point to each point direct is adopted, and the silence and the nuance between sound are reproduced transparently infinite. Form  Hybrid Integrated Amplifier  Output power  80W+80W (6 ohms, 20Hz - 20kHz)  THD  0.008% or less (6 ohms, 1kHz)  Frequency characteristic  1Hz - 200kHz-less than 3dB  Input sensitivity/impedance  Phono man month: 2.5mV/47kohm Phono MC: 125 microvolts/100 ohms compact disk, Tuner, audio video/AUX:150mV/40kohm  S/N ratio (A curve correction)  Phono MM:90dB Phono MC:70dB compact disk, Tuner, audio video/AUX:110dB  Supply voltage  AC100V, 50Hz/60Hz  Dimensions  Width 438x height 148x depth of 346mm  Weight  10.2kg